Configure Fault Management

This chapter describes the procedures to create and load the alarm profiles.

Create a Fault Profile

Perform this task to create a fault profile.

Procedure

Step 1

configure

Step 2

fault-profile name

Example:

RP/0/RP0:hostname (config)# fault-profile test

Creates a fault profile.

Step 3

fault-identifier subsystem type-of-the-subsystem fault-type type-of-the-fault fault-tag type-of-the-tag sas severity-of-the-alarm nsas severity-of-the-alarm

Example:

RP/0/RP0:hostname (config-fault-profile)# fault-identifier subsystem XR
			 fault-type HW_ETHERNET fault-tag ETHER_SIGLOSS sas CRITICAL nsas MAJOR

Configures the fault profile.

Step 4

fault-profile name-of-the-fault-profile description description-of-the-fault-profile

Example:

RP/0/RP0:hostname (config-fault-profile)# fault-profile test description this is test profile

Defines description of the profile.

Step 5

commit

Load a Fault Profile

Before you begin

Create a fault profile. See Create a Fault Profile.

Procedure

Step 1

configure

Step 2

fault-profile name-of-the-fault-profile

Example:

RP/0/RP0:hostname (config)# fault-profile test

Enter the fault profile configuration mode.

Step 3

apply rack 0 slot slot number portport numberpropagate

Example:

RP/0/RP0:hostname (config-fault-profile)# apply rack 0 slot LC2 port3 propagate

Loads the fault profile on the line card on port 3 of line card 2.

Step 4

commit