Configuration Guide for Cisco NCS 4000 Series

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Book Contents

Find Matches in This Book

Results

Updated:: April 28, 2023

Configuring Breakout

This chapter gives procedure to configure breakout.

Configure Breakout

Procedure

Step 1	configure
Step 2	controller optics R/S/I/P Example: `RP/0/RP0:hostname (config)# controller optics 0/0/0/1` Enters the Optics controller mode.
Step 3	otn framing framing type Example: `RP/0/RP0:hostname (config)# controller optics 0/0/0/1 breakout-mode 1 otn framing opu2` Configures OTN framing.
Step 4	commit

Example: Configure Breakout mode for Controller

The following example shows how to configure breakout-mode for a controller using Cisco IOS XR commands:


RP/0/RP0:hostname# configure terminal
RP/0/RP0:hostname(config)# controller optics 0/0/0/1
RP/0/RP0:hostname(config)# controller optics 0/0/0/1 breakout-mode 1
RP/0/RP0:hostname(config)# controller optics 0/0/0/1 breakout-mode 1 otn framing opu2
RP/0/RP0:hostname(config-otu1)#commit

Was this Document Helpful?

Feedback

Contact Cisco

Open a Support Case
(Requires a Cisco Service Contract)