MPLS-IP Configuration Mode Commands

Mode

The MPLS-IP Configuration Mode is used for configuration of Multiprotocol Label Switching (MPLS) IP forwarding specific parameters. This mode is entered from the Context Configuration Mode.

Exec > Global Configuration > Context Configuration > MPLS-IP Configuration

configure > context context_name > mpls-ip

Entering the above command sequence results in the following prompt: 

[context_name]host_name(config-mpls)#

Important

The commands or keywords/variables that are available are dependent on platform type, product version, and installed license(s).


Important

For information on common commands available in this configuration mode, refer to the Common Commands chapter.

protocol ldp

Creates or removes the MPLS label distribution protocol (LDP) configuration, or configures an existing protocol and enters the MPLS-LDP Configuration Mode in the current context. This command configures the protocol parameters for MPLS LDP.

Product

GGSN

P-GW

SAEGW

Privilege

Security Administrator, Administrator

Mode

Exec > Global Configuration > Context Configuration > MPLS-IP Configuration

configure > context context_name > mpls-ip

Entering the above command sequence results in the following prompt: 

[context_name]host_name(config-mpls)#

Syntax

[ no ] protocol ldp

no

Removes the configured MPLS-LDP mode from MPLS-IP Configuration mode.

Usage Guidelines

Use this command to create/ or remove the MPLS LDP configuration, or configure an existing protocol. If required mode already exists it enters the MPLS-LDP Configuration Mode in the current context.

Entering this command results in the following prompt: 

[context_name]hostname(config-ldp)#

The commands configured in this mode are defined in the MPLS-LDP Configuration Mode Commands chapter.

Example

The following command creates and enters the MPLS-LDP Protocol mode: 
protocol ldp