The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
Software Authentication Manager (SAM) is a component of the operating system that ensures that software being installed on the router is safe, and that the software does not run if its integrity has been compromised.
For information on SAM commands, see the Software Authentication Manager Commands module in System Security Command Reference for Cisco NCS 6000 Series Routers.
For information on setting the system clock, see the clock set command in Clock Commands module in System Management Command Reference for Cisco NCS 6000 Series Routers.
|
Release |
Modification |
|---|---|
|
Release 5.0.0 |
This feature was introduced. |
You must be in a user group associated with a task group that includes the proper task IDs. The command reference guides include the task IDs required for each command. If you suspect user group assignment is preventing you from using a command, contact your AAA administrator for assistance.
For SAM to verify software during installation, the software to be installed must be in a Packager for IOS/ENA (PIE) format. PIEs are digitally signed and SAM verifies the digital signature before allowing bits from that PIE to reside on the router. Each time an installed piece of software is run, SAM ensures that the integrity of the software is not been compromised since it was installed. SAM also verifies that software preinstalled on a flash card has not been tampered with while in transit.
When the initial image or a software package update is loaded on the router, SAM verifies the validity of the image by checking the expiration date of the certificate used to sign the image. If an error message is displayed indicating that your certificate has expired, check the system clock and verify that it is accurate. If the system clock is not set correctly, the system does not function properly.
When the SAM detects an abnormal condition during boot time, it prompts the user to take action and waits for a certain interval. When the user does not respond within this interval, SAM proceeds with a predetermined action that can also be configured.
To set up the Prompt Interval, perform the following tasks.
| Command or Action | Purpose | |
|---|---|---|
| Step 1 |
configure Example: |
Enters XR Config mode. |
| Step 2 |
sam promptinterval time-interval {proceed | terminate} Example: |
Sets the prompt interval in seconds, after which the SAM either proceeds or terminates the interval. The Prompt interval ranges from 0 to 300 seconds. If the user responds, SAM considers it as a ‘Yes’ and proceeds with the next action. If the user does not respond, SAM considers it as a ‘No’ and terminates the action. The default time for which SAM waits is 10 seconds. |
| Step 3 |
Use the commit or end command. |
commit —Saves the configuration changes and remains within the configuration session.
|
Feedback