Daisy Chain Network Command Reference

This chapter describes the commands to configure Daisy Chain Network.

bridge-port routed-interface

Use the bridge-port routed-interface command to bridge two ports. For example, when connecting multiple NCS 4000 devices in a Daisy Chain topology, use this command to bridge the EMS and Craft ports so that the traffic on EMS port is routed towards the Craft port.

bridge-port routed-interface type interface-path-id

Syntax Description

type

Specify the Management Ethernet interface.
interface-path-id

Specify the physical or virtual interface.

Command Default

None

Command Modes

Config mode

Command History

Release Modification
Release 6.5.33

This command was introduced.

Usage Guidelines

None

Task ID

Task ID Operation

ethernet-services

read, write

Examples

The following example shows how to bridge the Craft and EMS ports: 

RP/0/RP0:Node-41(config)#interface MgmtEth0/RP0/EMS/0
RP/0/RP0:Node-41(config-if)#no shutdown 
RP/0/RP0:Node-41(config-if)#ipv4 address 192.168.02.01/24
RP/0/RP0:Node-41(config)#interface MgmtEth0/RP0/CRAFT/0
RP/0/RP0:Node-41(config-if)#bridge-port routed-interface MgmtEth0/RP0/EMS/0
RP/0/RP0:Node-41(config-if)#no shutdown
Table 1. Related Commands
Command Description

interface (OSPF)

Use this command in area configuration mode to define the interfaces on which the Open Shortest Path First (OSPF) protocol runs.

no shutdown

Use this command to enable the Intermediate System-to-Intermediate System (IS-IS) protocol on a particular interface.

ipv4 address odu

Use this command to configure IP address for GCC on an ODUk controller.